KESS V2 WARNING the tool is not updated

Useful tips of truck kess v2 ksuite warning “the tool is not updated”.

Symptom:

Kess v2 ksuite warning: the tool is not updated. Connect the PC to the Internet and run again the software.

Optional solution:

1.Try different USB cable. Some users with the same problem fixed the problem by a new USB cable .

2.Reflash with J-Link …

Notice:
1. Do not update this tool online, or It will get damaged
2. Do remember disconnect internet when you use it

If you connect to internet with this clone kess v2 at www.obd2tool.com, or make online update. The interface is destroy/broken.

1.–Buy a new NPX chip with 60 tokens inside. Desolder the old NPX and change it with new. It cost 14-20

2.–or you have to weld a connector on backside of interface ,and plug the J-link programmer.
You can reset the ECU Chip Tuning Kess v2 to virgin.

Our customers feedback some problem about kess v2,we sovled it and have written below,if you have same problems,it will help you

http://obd2lily.nation2.com/kess-v2-not-works-with-k-line-or-does-not-work-wel

Ktag KTM100 V7.003 work as Original Trasdata

Is it possible to read edc17c64 with ktm100? Here is the test report of an Ktag expert.

And this is the post with the most likes:
“I made for my friend remap of skoda octavia 3 rs tdi. he bought ECU Scanners Ktag ktm100, the vendor send me dump, i made remap without doi decalibration and lambda for 1100 after 1000mg of air. car is running and starting without problem. i start writing here to know how upgrade to fake firmware v7.003. I think in clone Trasdata is allowed protocols menu with edc17c64 and edc17c66 if firmware = 7.003. with trasdata menu to confirmation then there is true and china ktm100 can do edc17c64 !!!”

Ordered KTM100 firmware v7.003 from obd36.com and received it last weekend.
ktm100 china is in fact trasdata i think…
Also it’s kind of the same as Ktag v6.070.
But this Ktag does not support BMW F chassis petrol and Mercedes-Benz W222
Only possible after fw 7.020 and ksuite 2.22 frm obd2tool.com

ktm100 can do edc17c64 gpt!!! (And no possible 2l tdi 184 edc17 c64 wi)
this is my photo of edc17c64 with china no reworked ktm100 done.

3-1

These new ecus i have tested:
BMW 520d F10 EDC17C41 DDE8

Volvo edc17cp48 GPT
Mercedes CLA 217 1.6turbo MED17.7.3 GPT
Honda Edc17 GPT (dont remember exact model)

All seems to work AS ORIGINAL. Toyota Denso included also! And Yes, same as others say, KTAG master KTM100 V2.23 Firmware V7.020 is FAKE Trasdata. 100% same tool, same software, same car list, same protocols, just different name. . ktag will not work with ktm100… only if you will apply one patch for this and change .ept…and will be trasdata.
http://obd2trade.com/2017/06/19/httpcheapobd2scanner-com20170619ktag-v7-020-and-ktag-ktm100-v7-003-comparison/